Benjamin Sheridan Blue Streak Co2 Air Rifle Repair Kits

Sheridan Pumper Rebuild Kits Pre-1995 & Post-1995

I offer two rebuild kits for older Sheridan pumpers. These kits come straight from a distributor. I AM NOT A SHERIDAN EXPERT. I know nothing about these kits. Please read the below descriptions (directly from the distributor) and choose accordingly. They sell well on Amazon and eBay, but make sure you read carefully and buy the correct kit.

Benjamin Sheridan Rebuild Repair Kit, Some Pre-1995 Multi-Pumps with Soldered Valve Valve Tool only available here Repair kit fits these multi-pump guns made before 1995 (they have a soldered valve): Benjamin 397, 392, 340, 342 & 347 guns as well as Sheridan C9 (Silver Streak) & CB9 (Blue Streak). To determine if this kit is for you: Remove the screw in front of trigger guard to remove rear part of the stock. Remove the pins or screws that hold the retention cap at the rear of the receiver. Remove the guide pin, spring & hammer to reveal the compression tube. If the compression tube appears to be brass & is one piece with a pin protruding from it, you'll need the other kit (CR/RepairKitC9) instead of this one. If your gun has a rounded square hole with a valve stem sticking up through it, then the kit shown on this page will fit your gun. The included valve tool (pictured on this page) is needed to remove the parts from the soldered valve body (directions included with kit). This kit includes parts that are still available from Crosman and may require slight modification. If your gun is very old and has been treated with any petroleum distillates and/or solvents that damage rubber seals, the removal of the old parts can be challenging. The obsolete gasket that seals the valve guide to the compression tube can normally be reused. If you used petroleum products, it may be irreparably damaged and will need to be replaced by a thin o-ring.
STOP! April / May 2020 The Pre kits are out of stock. You can order them, but they'll be on back order until mid- late-May. STOP! April / May 2020 The Pre kits are out of stock. You can order them, but they'll be on back order until mid- late-May.	STOP! April / May 2020 The Pre kits are out of stock. You can order them, but they'll be on back order until mid- late-May. STOP! April / May 2020 The Pre kits are out of stock. You can order them, but they'll be on back order until mid- late-May.
Valve Tool only available here

Benjamin Sheridan Rebuild Repair Kit, Some Post-1995 Multi Pumps with Cartridge Valve Repair kit fits these multi-pump guns made after 1995 & they have a compression tube that slides out of the assembly & does not need a special tool (has a cartridge valve & the valve is NOT soldered). It may be necessary to push out the assembly from the front of the tube: Benjamin 397 & 392 guns as well as Sheridan C9 (Silver Streak) & CB9 (Blue Streak). To determine if this kit is for you: Remove the screw in front of trigger guard to remove rear part of the stock Remove the pins or screws that hold the retention cap at the rear of the receiver Remove the guide pin, spring & hammer to reveal the compression tube If the brass compression tube comes out in one piece, then this is the kit you need If your gun has a rounded square hole with a valve stem sticking up through it, then you need the other repair kit (CR/Repairkit).

greenfrid1950.blogspot.com

Source: https://alliancehobby.com/sheridanrebuilds.htm

Share this post